Its all what you want to know about roofing and its problems

Its all what you want to know about roofing and its problems

Obvious or unforeseen, roof problems are always a pain and undoubtedly a significant expense. Buildings magazine examined which problems are most common and the conditions that can either cause or be the result of premature failure and reduced service life of low-slope roof systems. This is not a self-diagnostic guide, but rather an informative list of some of the problems most often battled by building owners and facilities professionals.

Leaking roofs can usually be repaired quite barely depending on how severe the damage to the roof is.  By locating the general area of the roof leak on your home the problem can be isolated and fixed fairly easily.  Most roof repair contractors can locate the cause of a roof leak quickly and will often explain the problem in wrong way.

The source of the roof leak is not always obvious. A leak may not be directly above the water stain on the ceiling or the wet spot on the attic floor; it may travel horizontally under the shingles and then down the roof sheathing before penetrating at a seam. Some apparent “leaks” may in fact be condensation on the underside of the roof caused by inadequate attic ventilation.

It helps to know the most common leak locations. The most obvious ones are wherever the roofing is visibly missing or damaged, but more often leaks occur at flashing points (valleys and roof penetrations). In northern climates, where roofs are exposed to snow and ice, roofs that are otherwise in perfect condition may leak in the lower foot or two of the roof when snow and ice build up, forming a dam that collects water from melting snow. If leaks occur only at these locations and under these conditions, the solution lies in preventing the dams (a matter of proper ceiling insulation and eave ventilation).

A roof structure has to be designed in such a way, that no ponding water can take place resulting in a structural failure or permanent deformation of the roof or its parts.

Important factors are here:

  • Sufficient stiffness of the roof and its components.
  • Sufficient rainwater discharge possibilities. In case of malfunctioning of the regular rainwater discharge system, an adequate overflow system has to be present. The strength and stiffness of the roof and its components has to be designed, detailed and executed keeping in mind the maximum overflow water levels.
  • ?Sufficient roof slope and or camber.

Another important fact is all roofings are subject to damage from strong winds and flying debris. Roofs, generally, are not designed to withstand winds of hurricane and tornado intensity. However, the greatest damage to roofs is not necessarily from hurricanes but, rather, from winds of moderate intensity and the gusts that may reach to higher miles per hour that accompany them. Asphalt roofings, particularly free-tab asphalt shingles, improperly applied arc probably most susceptible to wind damage.

Another cause of wind damage to roofs is the partial vacuum caused by wind blowing perpendicularly over the ridge of a roof and causing the roll roofing to tug at its reroofing has been requested when repair of the flashings or provision for new flashings was all that was required to make the roof leak-proof. When it is considered that the function of flashings is to provide a waterproof junction between the roof and other parts of the structure and between roof sections, their importance, and the importance of maintaining them properly cannot be overemphasized.

Some maintenance tasks are common to all types of roofs; others are specific to the particular roof type. Some tasks will need to be completed more often if you live close to the sea or in a geothermal area. Check with the manufacturer of your roof for specific maintenance requirements.

Roofs are no longer merely the skin on the top of a building. Today, the roof is an integrated component of a complex building envelope system that includes the foundation, walls, windows, masonry and structural components. All those components combine to provide an energy efficient, waterproof envelope. With energy efficiency becoming a crucial goal, the roof is expected to perform functions beyond merely providing a waterproof surface on the top of the building.

Sometimes, a roof might appear to leak in January when the temperature dips below freezing, but the roof might not be leaking. What happens is condensation is created when the warm, moist interior air inside the building contacts cold surfaces or when cold air leaks through the building’s exterior skin.

This problem might result from a missing or inadequate air barrier or vapor retarder on ceilings or walls, or from inadequate insulation or ventilation. Cold areas above the insulation in joist cavities or attic spaces must be vented. If natural ventilation is difficult or too expensive, technicians can install a fan that moves moist air out of the cold space.

Lack of maintenance is a key reason why old buildings deteriorate. Maintenance essentially means preventing rainwater getting in where it can cause harm. It is commonly said that water is potentially most likely to enter through the roof, so putting right minor problems here before they worsen can avert the need for more extensive repair.

Resources:

Roof Coatings

Roof Leaks

Elastomeric Roof Coatings

Watch this video about roof repair contractor

Please help to answer the question about roof repair contractorAttention Roofing Contractors, or people who know or work with one:?
I know rain is somewhat a mixed blessing: rain is BAD in that it delays a contractor from working, yet it is GOOD because it wears on the roof making an otherwise good roof in need of repairs/replacement sooner (lengthens, yet increases, backlog).

In terms of heat (not so much extreme heat, but just hot weather): Is it good, bad, or mixed (as it is with rain).

Thanks in advance – I'm trying to better understand the moving parts of the industry… Please explain, and source for the "Best Answer"
About Author

Author has done a lot of research work on different roof coatings materials and have written many articles on roofing materials used for repairing Roof Leaks. In addition, the author is well aware about the problem of roof leaks.




Related Its all what you want to know about roofing and its problems:
March 28th, 2011 | by roofing contractor |

14 Responses to “Its all what you want to know about roofing and its problems”

  1. By Pepibom on Jan 31, 2010

    My husband is a roofer and try calling in a roofing company to a look at it well at both roofs so you will know where it is leaking

  2. By rabeeka on Jan 31, 2010

  3. By Business Loan Rates on Jan 31, 2010

    wow

  4. By Auto Loan Finance on Jan 31, 2010

    holy shit ur awesome i wish i had ur talent keep up that good work/natacha

  5. By Secure Finance Business on Feb 1, 2010

    can’t believe it’s drawn out of nothing, could be a photography!

  6. By Mashu on Feb 1, 2010

    If it jumps or tries to die when you release the clutch then it has to be your clutch. Also check your fuel pump or relay fuel pump.

  7. By Loan Mortgage on Feb 1, 2010

    Incredible! He looks so life like. Just amazing…and what a beautiful subject

  8. By Baila on Feb 1, 2010

    Liquid rubber is typically used on flat roofs, but will work on sloping roofs. If you know where the leak is, then liquid rubber will work fine. Ultimately, you should have the roof replaced. If it's an old roof, it will start leaking in other spots also.

  9. By Business Loan Rates on Feb 1, 2010

    Great talent Der Mann.

  10. By ladydavonia on Feb 2, 2010

    $33,000 is far too low a price for a house and land! It's the most valuable family asset you could have, and you should never settle for just giving it away.

    In today's market, you should be able to put the money into it over time, do the work yourself, and sell it for $100,000 minimum. Don't settle for less!

    This may sound crazy and unrealistic, but this is what I've done with my own house. It's 101 years old, it's now fully insulated (walls and ceilings), it has a new furnace, a new 200-amp service, a 3-car garage (used to be a small barn), metal roof and siding, 20-year carpet and Pergo floors, high ceilings, ceiling fans, 5-foot fence around a large back yard, and just 2 years ago a bank "settled" for $66,000 (it was a repo) and they had left it half finished and pretty nasty inside.

    In total, I've paid the $66,000 + about $16,000 for improvements. I wouldn't let it go for under $150,000.

    If I were you, I would get a home improvement loan for $15,000 and give them a plan.

    1) Roof first (always)
    2) Plumbing and electrical next (update the box only if you need it)

    **the best time to do electrical work is when you anticipate tearing out walls.

    3) Cosmetic repairs almost last
    4) Outdoor repairs last

    Part of your plan should be a study for what other similar houses are selling for in the area so that you have an idea of what yours will be worth when its done.

  11. By Small Business Investment on Feb 2, 2010

    *sub*

  12. By Construction Loan Finance on Feb 2, 2010

    whoa!!it looks like a PICTURE!
    ur an amazing painter!:D

  13. By All Finance Direct on Feb 2, 2010

    Excellent work. Pleasure to watch. Perfect music :-) ))

  14. By BERT on Feb 3, 2010

    contractors (at least in washington state) need to be licensed,. Make sure you get the name of his company and license # and call to verify this is actually his license #. this is a big scam in my state when unlicensed contractors steal the #s of reputable licensed guys and rip people off. then you can go to angie's list and see if there are any reviews for them. do not pay all the money upfront, get your contract in writing included his start date. if you need to have it finished by no later than a certain date you need to have this specified. that way he does not start take half of the money and leave you hanging for a long time. this is called a "time is of the essence" clause in legal terms. make sure there are one of these in the contract. also state that any "extras" not included in the original bid that come up during the process whether it be materials or labor costs need to be submitted to you in writing for approval. if he is not ok with this he is not the guy for you. get a couple bids before you pick in this economy these guys are really fighting for business. do your research on them before you go with them. good luck!

Post a Comment