Starting Your Home Renovation Ideas and Maintenance in the Fall

Starting Your Home Renovation Ideas and Maintenance in the Fall

By doing a small amount of preemptive maintenance now, you can prevent minor problems from escalating into a major problem later in the year. By doing these small repairs now, you can prevent air, rust and moisture penetration from attacking the structural integrity of your home down the road and seriously bringing down it’s value.

Cleaning the eavestroughs in the fall, for example, can prevent ice damming in the winter, where moisture is forced up under the roof’s shingles during winter’s freeze-thaw cycles. “Our roofing contractors are always busy in the spring, fixing damage and leaks that have occurred because of ice damming,” Felton added.

Here are some home maintenance ideas jobs that should be on a homeowner’s winterizing checklist:

“    Clean eavestroughs after the last leaves have fallen. Run a garden hose and check that they are draining properly and that downspouts are operating and directed away from the home’s foundation walls. Check for leaking or damaged gutters, downspouts and hangers. Remove rust and patch the gutters with roofing cement. Caulk leaking seams and make sure pop rivets are secure.
“    Check the roof for trouble signs such as broken or missing shingles, cracked, buckling or curling shingles, or bare spots where the granular coating has worn off. Check flashing around vents, skylights and chimneys. Look for pieces that have peeled back and for cracked caulking that could allow moisture penetration.
“    Have the chimney cleaned and check the exterior structure for worn flashing, loose bricks or crumbling mortar.
“    Have your furnace cleaned, inspected and safety checked. Depending on the system, you will need to have the furnace vacuumed, the filter changed and the pilot checked.
“    Check for blockage of attic louvres by wasp’s nests and put sheet metal, wire screen or wood over any openings, including under the eaves, to prevent animals from nesting.
“    Remove and store your window air conditioner. Make sure to clean the coils and filters and cover loosely for the winter. If you are leaving the air conditioner in the window, put a weatherproof cover over it to protect it during the winter.
“    Clean your lawnmower and other garden tools before storing. Give all the metal parts of your tools a wipe with an oiled rag to prevent rusting. Drain the fuel from gas-powered machines and run the engine until the lines are clear. Drain the oil and replace it. Clean caked-on grass and debris.
“    Check doors and windows for proper caulking and weatherstripping. Do the draft test: hold a lit candle and run it along the seams of doors and windows. A flickering flame means your heating dollars are going out the window.  Check the bottoms of doors for a snug threshold seal or door sweep.
“    Make sure your fireplace is in safe working order. Check that the damper opens and closes smoothly and fits properly to prevent heat loss. Check inside the fireplace to make sure no bricks are loose or broken. If your fireplace is smoking excessively, check the chimney for fallen bricks. Installing a chimney cap can cure a smoking fireplace by improving the draft.
“    Drain exterior water lines, hose bibs, sprinklers, and pool equipment before the first major freeze. Caulk around pipes where they enter the house.

“    Clean your barbecue and store it in a protected place for the winter. Never store propane tanks indoors.
“    Clean patio furniture and store, loosely covered, in a dry place.
“    Wash windows to let in the maximum heat and light during cold winter days.

Doing your fall chores can make your life easier come spring, when you would rather be fishing than fixing winter damage. There are a lot more tips in our categories section.

http://easybasementrenovations.com/starting-your-home-renovation-ideas-and-maintenance-in-the-fall

Watch this video about metal roof contractor

FBI Contracting LLC www.localedge.com Door Contractors,Roofing Contractors, Roof Repair, Siding Contractors, Roofing Repair, Vinyl Windows, Metal Roofing, Vinyl Siding, Door Repair, Windows Contractors, Please help to answer the question about metal roof contractorDoes anyone have a basic idea of the cost to replace a roof nowadays on a 1600sq ft home in Southwest Florida?
We're thinking of replacing our shingle roof with a metal one.
Where is the best place to search for a reliable roofing contractor?
Thanks for your help!
About Author

chicodogs -
About the Author:

http://easybasementrenovations.com




Related Starting Your Home Renovation Ideas and Maintenance in the Fall:
June 8th, 2010 | by roofing contractor |

9 Responses to “Starting Your Home Renovation Ideas and Maintenance in the Fall”

  1. By biggun on Jun 9, 2010

    The restaurant industry has slip resistant shoes that work very well in greasy conditions. But they won't have steel toes or shanks.

    http://www.knotlimited.com/servlet/ProductList?command=createProcurement&supplierID=353&manuID=353&categoryID=2146&categoryName=Men%27s+Slip-Resistant+Shoes
    http://www.foodservice.com/iexhibit/shoesforcrews/products.cfm
    http://www.standingcomfort.com/shoes/chef-shoes.html

    And I actually found some work boots that advertise themselves as slip resistant…

    http://www.nonslipandsteelshoes.com/vendor/worx%20by%20red%20wing.htm

  2. By DL on Jun 9, 2010

    Warranties on roofing materials are rarely used, for several reasons:
    1. The bulk of the cost is in labor, rather than materials.
    2. Manufacturers only cover defective materials, and the vast majority of problems with your roof are caused by incorrect installation, inappropriate materials given your location, "acts of God", etc.
    3. Even if you do determine that you have defective materials, the warranty is typically pro-rated after a few years, so that after 10 years you'd only get a percentage of the amount you had originally spent.

    It is much more important to get a guarantee from the roofing contractor that you hired.

    Finally, although proof of purchase is helpful, it isn't usually required by manufacturers. Most roofing materials include a serial number or other method of identification, and this should be adequate should you wish to invoke the warranty. This article provides more detail: http://www.roofery.com/shingles/warranty.html.

  3. By Wordpress on Jun 9, 2010

    Very nice job

  4. By billaryboy on Jun 9, 2010

    HCl is soluble in water. Adding water to a HCl solution dilutes the acid. Add enough water and the HCl solution approaches the acidity of rain water. The HCl has been completely washed away by 3 days of rain. There certainly won't be any HCl solution left on the roof. The HCl was probably washed away by the contractor when he rinsed off the roof after cleaning it.

    The owner is confused about HCl. The gas, HCl, ionizes in water and is corrosive. Exposing the roof to concentrated HCl solution is more corrosive than exposing a dry rood to HCl gas. However, the more water you add to a HCl solution, the weaker (and less corrosive) it becomes.

  5. By OMEGA1 on Jun 10, 2010

    There are so many variables here that anything we say will only be a guess. The condition of your roof, the whole roof, not just the shingles, how many layers of shingles are on the roof right now, what the local codes require, most will allow two layers of shingles but not three. When I have a situation like this, I call the local building inspector and ask him/her, after all they are the ones that will have the final say. The inspectors in my area don't mind stopping by and giving their opinion.

  6. By gc27858 on Jun 11, 2010

    You have to have ventilation. Metal is not an insulator, it's a conductor. If it's shiny it will reflect, but it won't stay shiny. If there is insulation under the metal, then the reflective quality will be helpful, but if not, the metal will heat up and it will get hotter than hell in your attic, and make your AC work harder. The more ventilation you have, the better. Ridge vents are good.
    The problem with your existing fans is that they were made to install on a shingle roof, and the flange is probably full of nail holes and roofing cement, and hard to tie in on a metal roof. They can probably be modified in various ways, (e.g. curb mounted), by a good sheetmetal mechanic to work with a metal roof, and hopefully, your roofer is a good sheetmetal mechanic. Alternatively you could put gable fans, if you have gables.

  7. By lyn g on Jun 11, 2010

    A metal roof is not installed by a plumber, it would be installed by a roofer or a sheet metal worker.

  8. By rock 1050 on Jun 11, 2010

  9. By billaryboy on Jun 12, 2010

    Hcl eats metal. If there were holes in the enamel the acid when applied would attack the roofing. The damage would be immediate and obvious.

    Hcl becomes diluted (weaker) when you add water. If the contractor was careful to rinse well and then you had three days of rain it's hard to imagine any acid residue could have remained or done any damage.

    You might buy one piece of roofing and duplicate the cleaning and flushing process to see if it damages the metal. This could provide some insights.

    good luck.

Post a Comment